EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Merrillville
> Self Propelled
> Air Brakes
> Under 150 PSI
> New clarke 190EN mig welder kit 220V gas/no gas
New clarke 190EN mig welder kit 220V gas/no gas
*NEW* Clarke USA 190EN MIG/Fluxcore Wire Welder KIT plus regulator, helmet, welding gloves, and welding cart (220V)
This NEW in factory sealed box Clarke 190EN MIG/Fluxcore 220V Wire Feed Welder KIT is easily converted from Gas to Fluxcore welding and will easily weld 1/4 in. steel in a single pass! Electronic wire speed control and 6 variable heat settings allow you to precisely adjust the welder to your needs and is fan cooled for better performance. Operates on 220 volt electrical supply. You will be getting this NEW in factory sealed box Clarke 190EN welder along with New Clarke gas regulator, welding cart, welding helmet, welding gloves, roll of wire, chipping hammer, welding mask, and manual.
* Easily welds 1/4" in a single pass
* Solid state electronic heat control with large PC board for better wire speed control
* Weld steel, aluminum, stainless, copper and cast iron, requires correct wire and gas
* Automatic thermal safety switch prevents overload
* Input 230V, 60HZ, 25 Amps, 1 ph
