EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Hammond
> Heavy Machinery
> Electrical
> High Frequency Converters
> Under 1 MhZ
> Cable wire feeder conduit ultra tugger set-up n/r
Cable wire feeder conduit ultra tugger set-up n/r
CABLE WIRE FEEDER CONDUIT ULTRA TUGGER SET-UP N/R
This unit is set up like Greenlee's Ultra Cable Feeder. This unit just needs a variable speed motor, and hand control to operate. Great alternative and opportunity to SAVE THOUSANDS! A complete unit like this would cost about $7,000.00. By adding a motor to the square drive, you can control the speed and capacity of this unit. Below are the specs for this unit;
Top Tire is a 12 x 8.00-6 Maxxis
Bottom Tire is a 20.5 x 8.0-10 Nankang
Frame is Structural Channel and tubing
Front and Rear steel guide rollers