EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Hammond
> Agricultural and Construiction
> Food
> New * * clarke 130EN mig/fluxcore welder 110V gas/no gas
New * * clarke 130EN mig/fluxcore welder 110V gas/no gas
*NEW* Clarke USA 130EN WE6523 MIG/Fluxcore Wire Welder (110V)
New in factory sealed box Clarke 130EN MIG/Fluxcore Wire Feed Welder is easily converted from Gas to Fluxcore welding and will weld up to 1/4" inch steel in a single pass! Features Tweco-style torch with full On/Off Safetly Control. Electronic wire speed control and 4 variable heat settings allow you to precisely adjust the welder to your needs. Operates on standard 110 volt electrical supply. You will be getting this new in factory sealed box Clarke 130EN welder along with roll of wire, chipping hammer, and manual as well but NO Regulator. Check out the new Clarke gas regulator to go along with if you will be doing gas welding in my other listings!
* Tweco-style torch with full On/Off Safety control
* Advanced safety overload protection for transformer
* 4 power settings for maximum welding heat control
* Welds up to 1/4 in a single pass
* Uses Fluxcore or solid steel welding wire
* Input: 120V, 60 Hz, 13A, 1 Ph
* MAX O.C.V. = 30 VDC MAX 85A
