EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Gary Indiana
> Agricultural and Construiction
> Fertilizer Production and Distrobution
> Cnc 3 axis stepper motor driver router , 60V/5.0A ii
Cnc 3 axis stepper motor driver router , 60V/5.0A ii
CNC 3 Axis Stepper motor Driver ROUTER,MILL , 60V/5.0A II
* provide the 12-wires OC output , the output port can drive the SSR ( solide-state realy ) directly.
* 12-wires optical isolated common signal input
* all the input and output have the signal alarm
* single power supply 13-24VDC
* all the input signals of the PC parallel port are modified by the Schmitt Trigger and increase the anti-jamming capacity of the transmission of the digital signal
* Using Mach 2, 3 as the controlling software, makes the application of the PC as the industrial control possible
* as the lack of the IO of the PC parallel port, we add 3 axis 6bit independent Limit switch of the IO input
* compatible with all the pusle and direction signal of the Stepper or Servo driver , can control the lathe and milling machine to work
* the input part can connect to the mechanical switch , groove optocoupler, proximity switch , tool presetter etc.
* the interface board P1-P17 port correspond to the pin1-17 of the PC parallel port , the parallel port pin 18-25 is the GND.
* control the 2-wires electromagnetic relay output by the parallel P1 and P16 , this can control the cooling pump and lubricating oil pumpof the lathe
* the setup of the P17 in the Mach 3 for the charge pump can control the solide state relay output to increase the safety of the lathe.
* the P14 can provide the accurate 0-10V analog voltage for the main axis speed control signal , this can make the frenquency of the speed of the spindle
* the dimension: 170mm*115mm locating hole: 119mm*101mm
* Power Input: 24V to 60 VDC or 20-40V AC
* Phase Current: adjustable from 1.5 A to 5A(1.5A,2.0A, 2.5A,3.0A,3.5A,4.0A,4.5A,5.0A)
* Resolution: 1/2, 1/8, 1/16 1/32 1/64 1/128 1/256
* Overheat, Over Voltage, Over Current Protection
* Dimension: 150mm x 98mm x 45mm
* Working environment: temperature: -15 -40 , humidity : RH<90%
* Input mode: monopulse and dipulse compatible
* AC,AConnect 20 to 60V DC power Supply
* Step+ (CP+), 5V Step- (CP-) pulse input
S7: 1=half current 0=full currren
