EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Gary Indiana
> Agricultural and Construiction
> Animal Feed
> Tektronix oscilloscope 2445A with digital multimeter
Tektronix oscilloscope 2445A with digital multimeter
Tektronix Oscilloscope 2445A with built-in digital multimeter 150 Mhz This scope is in clean, very good condition with only low hour of lab use on it. Users Manual 10x Tektronix test probes Test probe tip adapters CRT photo shroud
Testing of this Unit: Please Note:For all but the most critical applications, this piece of test equipment is ready to go. This instrument was last calibrated to national standards in 2005. Upon power-up the scope displays "Test 04 Fail10". Indicating a calibration error on Ch4. In run mode, all inputs display properly and with my signal generator I cannot detect the wave error on Ch4. For some very critical applications Ch4 should be recalibrated to national standards. In the listing photo Ch4 is displaying a 2.5 volt, gate generated square wave.
