EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > East Chicago
> Agricultural and Construiction
> 7" x 38" timesaver ? sander belt lower drum refurbished
7" x 38" timesaver ? sander belt lower drum refurbished
This is a refurbished belt sander lower drum that measures 7" diameter by 38" long
The steel shafting on both ends measures 1-15/16" in Diameter.
The two bearings measure 44-3/4" outside to outside face as shown in picture #2.
The rubber tire appears to have been redone/retreaded, it does not look worn ,
the cut grooves in the rubber face are about 5/16" deep and the edges of the treads are not rounded off
I purchased this roller/drum to build a homemade drum sander, but never got around to it.
The shafts were rusty when I bought it, I have cleaned them up with some emery cloth tape.
There is some pitting on the shafts from the rust,
but the two 1-15/16" dia. Link Belt spherical roller bearings I bought for it are a tight slip on fit on the shafts with zero play
Without the bearing in place, the longer 1-15/16" shaft on the drive end is about 6" long
It weighs about 125 lbs as shown, WITHOUT the two bearings and about 150 lbs with the two bearings in place
We will pack the two bearings in a separate box that should weight about 25 lbs.
