EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Dolton IL
> Self Propelled
> Foudation Brakes
> Everett 22 inch contractors chop saw metal or wood
Everett 22 inch contractors chop saw metal or wood
This is a nice, clean, low hour saw with a totally enclosed fan cooled Baldor 7.5 HP Three Phase 230 Volt Motor. This was a theft recovery and is missing the data plate from the motor, everything else is there and perfect, including the Blade Wrench. See specifications below This is a $3000.00 Chop Saw that you can steal for much less (pun intended). This is one serious chop saw!
Currently setup for Metal, Perfect for Pipe and Metal Building Construction, just install 20 inch Table Saw Blade with 1 inch arbor and remove from stand and you have a Chop Saw for Building Log Cabins...
Use on Job Site with Three Phase Generator, you can also switch out to Single Phase Motor, 5HP would be fine for Wood...
Most items I get I will clean to make them look better. I intentionally left this dirty to show how little use the machine has actually had.
Everett Industries, an abrasive cut-off machine & wheel manufacturer since 1962, is known for manufacturing abrasive cutoff saws & wheels that perform the best, last the longest & provide the most value on the market today. Everett offers a wide variety of cutoff saws & wheels for many applications.
Everett Abrasive Metal Saws are for metal cutting, steel cutting, stainless steel cutting, copper cutting, brass cutting, tube cutting, pipe cutting, wire rope cutting, hydraulic hose cutting, exotic alloy cutting, golf club shaft cutting, linear bearing cutting, rebar cutting, reinforce rod cutting titanium cutting, aluminum cutting, copper cutting, cast iron cutting, Iconel cutting, Stellite cutting, fabricated shapes cutting, structural shapes cutting and plastic cutting, etc. & are used in production maintenance or fabrication.
Dry Cutting: 20"-22" Contractors Abrasive Cutoff Machine
Complete with 7.5HP TEFC motor, magnetic starter with 110 volt at the pushbuttons, V shaped chain hold-down vise and steel stand.
For Cutting Up to 6" Pipe, Conduit and Metal Stock
This rugged, but portable, Everett model was specially designed for the job site. The Contractor s Model comes complete with magnetic starter with 110 volt at the pushbutton, stand and foot pedal operated vise. The special high-torque motor is totally enclosed and fan cooled.
