EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Dolton IL
> Heavy Machinery
> Components
> Preprime wb - clear primer - waterborne epoxy primer
Preprime wb - clear primer - waterborne epoxy primer
Preprime WB / Clear Primer - 1 Gallon (250 + sq ft)
Original Color Chips Waterborne Epoxy Primer is a two-component liquid epoxy emulsion. It's a low-solids epoxy
designed to sink deep into the concrete substrate to allow subsequent coatings better adhesion and uniform sheen.
It can be applied on interior floors, walls, ceilings, and machinery equipment. It hardens to a tough tile-like finish.
Particularly suitable on almost any surface, in areas where an inexpensive, easy to clean and wear resistant coating
is required. This waterborne epoxy primer can be used to prime a concrete substrate for use with waterborne, solvent-
borne, or 100% solids epoxy products.
No smell, non-toxic, ideal for in-plant application
Resistant to mild corrosive chemicals
Highly scrub and wear resistant
3 parts A to 1 part B (hardener)
All surfaces to be coated should be free of wash, oil,
grease or any other contaminant. Should be properly
etched using chemical or mechanical means.
It is recommended to stir part A before adding part B
as some soft setting may occur in the containers
Mix parts A and B mechanically for 5 minutes in
Apply thick using a 3/8" nap roller for best results.
Recoating: You can recoat over this product at the
point where you cannot leave your fingerprint in the
epoxy. If you press your finger onto the coating and
you cannot see your fingerprint you are ready to apply
Do not apply material at temperatures below
Material might be affected by certain corrosive
Click the following link for this item's Product Data Sheet
