EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Merrillville
> Self Propelled
> Stepper motor control& driver board i (2 control modes)
Stepper motor control& driver board i (2 control modes)
Stepper Motor Controller & Driver Board I (2A)
This item include: one Board I + one 4-pin cable
This stepper motor control&drive board has two control modes switched by jumper JP1:
1. By pulse and signals (JP1 Off)
Input pulse and signals to control the motor run, stop and direction.
There are 3 buttons marked "INC""DEC""FUN" on the board, you can press them to control stepper motor accelerate/decelerate, CW/CCW, stop etc.
For the board's flexibility (it can work even without pulse), so it suit for experiment demo, prototype making, student training, people DIY etc.
1. Matching motors: 6 wires or 4 wires stepper motor, 2-phase, amperage<2A, voltage: DC3V-DC40V.
2. Need two power supplies: 5VDC for the board; 3-40VDC for stepper motor (corresponding to your motor votage).
3. Motor speed can be adjusted and memorized.
VCC, GND: 3-40VDC power supply
(If it's 6 wires motor, just let the common wires empty.)
2. Pins Connection & Jumpers setting
a. Control by pulse and signals (JP1 Off)
b. Control by buttons (JP1 On)
INC: Acceleration (One time of pressure, one speed level upgraded. You will find it turn faster apparently after several times of pressure.)
DEC: Deceleration (Though CCW run, you will find it slow down apparently after several times of pressure.)
(Suggest you can mount-on JP2 after speed adjustment, then it be memorized even power off.)
2. Please turn off power supply before you mount-on or remove the jumpers.
