EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Merrillville
> Agricultural and Construiction
> Food
> Roofmate roof insulation panel full pallet - 50 pieces
Roofmate roof insulation panel full pallet - 50 pieces
we have aprox 3000 of these insulation roof panels available
they are manufactured by dow columbia - are used for roof insulation, insulation under concrete floor, insulation outside of concrete foundation for cold storage or cold environments, and as siding on buildings ... can install any tile or concrete finish over the top.
they are 2.5" of polystyrene insulation with 1/2" of polymer concrete coating on top ... you can walk on them
will give discount for full truck load
STYROFOAM< BRAND INSULATION PRODUCT DATA SHEET GENERAL DESCRIPTION STYROFOAM.. brand insulation is a closed cell, rigid plastic, extruded polystyrene foam insulation. BASIC USE STYROFOAM brand insulation is designed for use in roof, wall and foundation insulation applications in new or retrofit commercial structures. STYROFOAM RoofMate is intended for use on top of roofing/waterproofing membranes in ballasted IRMA/PMR (Inverted Roof Membrane Assembly/Protected Membrane Roof) applications. STYROFOAM PlazaMate and HighLoad 100 are intended for use above roofing/waterproofing membranes in roof, plaza or parking deck applications where high compressive strength is required. SIZES STYROFOAM brand insulation is available in panels 24 inches wide X 96 inches long in thicknesses of 1 inch to 4 inches depending on the product type. TECHNICAL SPECIFICATIONS TEST METHOD ROOFMATE PLAZAMATE HIGH LOAD 100 PROPERTY THERMAL RESISTANCE 5.0 5.0 5.0 Aged R-value/inch @75 F mean. ASTM C518 (0.88) (0.88) (0.88) temp., ft2*hr* F/Btu, (M2*K/w) COMPRESSIVE STRENGTH1 40 60 100 ASTM D1621 psi, (kPa), min. (276) (413) (689) FLEXURAL STRENGTH 60 75 100 ASTM C203 psi, (kPa), min. (413) (517) (689) WATER ABSORPTION ASTM C272 0.1 0.1 0.1 % by volume, max. WATER VAPOR PERMEANCE2 0.3-0.8 0.3-0.8 0.6-1.1 ASTM E96 perm, (ng/(Pa*s*m2)) (17.2-46.0) (17.2-46.0) (34.5-63.2) DIMENSIONAL STABILTY ASTM D2126 2.0 2.0 2.0 % linear change, max. LINEAR COEFFICIENT OF THERMAL EXPANSION -3.5 X 10-5 3.5 X 10-5 3.5 X 10-5 in./in.* F, (mm/mm* C) TYPE ASTM C578 VI VII V MAXIMUM USE TEMPERATURE 165 165 165 - F, ( C) (74) (74) (74) 1. At 10% deformation or yield, whichever occurs first. Since STYROFOAM is a visco-elastic material, adequate design safety factors should be used to prevent long-term creep static loads, 3 to 1; dynamic loads, 5 to 1. 2. Values based on desicant method. Vapor permeance varies with type and thickness. jack davis (***) 953-4120
