EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Merrillville
> Agricultural and Construiction
> Food
> Makita 12V hazardous location driver cordless r=$1800+
Makita 12V hazardous location driver cordless r=$1800+
MAKITA 1/4" Hazardous Location Driver Kit
Tim "HAZLOC" is a brushless and sparkless 12-volt driver for removing and replacing aircraft panels. This driver will save countless maintenance man hours spent working on overtorqued aircraft panels and Fasteners. This driver is Underwriters Laboratories certified, meets NEC article 513 aircraft-hangar requirements, and has been tested to MilStd 810F, method 511.4 explosive atmosphere. The BFH040SAE version is seven-to-40-inch pounds.This driver is for us in aircraft maintenance in Class I, Division 2 locations.
The driver has a built-in, torque-limiting system that prevents fastener overtorque. The built-in limiter shuts off the driver when the preset torque is reached-accuracy is plus or minus 10 percent. The driver weighs only 3.3 pounds and is nicely balanced. The drive has five key features: a quick change quarter-inch hex chuck, LED indicator for low battery, forward and reverse switch, battery slide switch, and anti-slip dimpled grip. The driver kit includes a driver, two 12-volt, 2.0-amp batteries, one charger, and a steel case. A few restrictions apply: The drivers are not designed to be, nor are they approved for use, as a drill. They also are not a substitute for a torque wrench.
RICK 063009-S-J-4-1447 (Multiple)
TESTED BY CHRIS-REVISED BY SCOTT-042810
