EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Hammond
> Light Machinery
> Lot (250) music wire translator pins for ate 3.75 inch
Lot (250) music wire translator pins for ate 3.75 inch
We picked up a bunch of the "nails" used in "bed-of-nails" ATE
testing and can offer them in economical and convenient small
automatic test equipment ATE system.
Brands are typically Giese International or similar.Most appear to
be unused, super clean, and most are apparently in "as new" condition.
Length is 3.75 inch, and there is no retaining crimp near one end. Ends
are typically flattened conical or nonsharp pointed. You have your choice
of .022 inch or .051 inch diameters. Standard uninsulated, nickel
These pins are normally used to translate between your custom
circuit positions and standard spacing on your test device. They
typically allow up to 0.4 inches of lateral adjustment. Easily
matching just about any printed circuit or terminal pattern. Works
equally well for SMT or thru-hole.
These should also have lots of general hobby or craft uses,
especially for model railroading. Fairly easily cut or bend with
Figure shown is of a similar item. Pins offered here do not have
You can click here to reach the Giese website.
Guaranteed usable. Count may be approximate and an occasional mis-sized
or mis-styled pin may be included.
translator pins. Be sure to specify .022 inch or .051 inch diameters.
Other styles and variations are also available. Guaranteed usable.
