EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Hammond
> Agricultural and Construiction
> Plants
> 10 polypropylene male adapter fittings ½ tube x 3/8 npt
10 polypropylene male adapter fittings ½ tube x 3/8 npt
These were purchased from an industrial liquidator earlier this year, and they were brand new in the original factory boxes and bags. They are perfectly clean, and we bagged them in 4mil Ziplok bags for resale. Simply insert your 1/2" OD (outside diameter) plastic tubing, tighten finger-tight, then tighten 1.5 - 2 turns with a wrench. The internal ferrule tightens around the tubing to prevent leaking, while the plastic grip ring prevents the tubing from being pulled out. Can be used with either soft or rigid plastic tubing, at a maximum pressure of 150 PSI. FDA and NSF rated for use with foods, beverages, pharmaceuticals, etc.
These fittings can be reused multiple times for low pressure, non-critical applications if the nuts are only tightened moderately. However, if you crank them down tightly with a wrench, new ferrules will be required before they can be used again.
Tubing size: 1/2" OD (outside diameter)
