EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Dolton IL
> Agricultural and Construiction
> New fire suppression system for new 5' hood
New fire suppression system for new 5' hood
ACityDiscount Restaurant Equipment: Superior Hoods Fire Suppression System for 5' Hood FIRE SUPP-5 Only Available When Ordering a NEW Hood - Manufacturer: Superior Hoods - Model: FIRE SUPP-5
ACDID23902 ACDMA944 ACDCA57082 ACDSEP ACDSP ACDTY7 ACDGC PeSAMember
Superior Hoods Fire Suppression System for 5' Hood FIRE SUPP-5
Only Available When Ordering a NEW Hood
Fire Suppression is only available for new Hoods purchased from ACityDiscount.
This listing is for the ADDITION of a Fire Suppression System for a new 5' Hood.
This system is for medium to high heat applications. Standard cooking equipment such as 1-Fryer, Ranges, Griddles, etc are considered medium to high heat.
Superior Hoods uses a highly effective liquid suppressing agent that fights fires three ways:
1. Breaks the Chemical Reaction by interrupting the chemical chain that causes fires to spread intensify. It stops fire cold.
2. Creates Steam and Cools, reducing damage and helps prevent re ignition.
3. Smothers the Fire, when discharged, a chemical chain reaction produces a soapy foam. Oxygen is cut off. The fire goes out. The thick layer of foam reduces the possibilities of re ignition.
* Listed by Underwriters Laboratories, Inc., tested to UL 300
* Listed by Underwriters Laboratories of Canada, tested to ULC/ORD-1254C.6
* Conforms to NFPA standards 17A and 96
* New York City MEA approval
Equipment that emits EXCESSIVE heat, flames, smoke, or which produces higher than usual Grease Ladened Vapors (such as 2 Fryers) would require a custom system. To order, contact our Hood Specialists on (***)-752-6715.
Installed Fire Suppression System will require an equipment layout.
For maximum 2" Gas Valve which equals roughly 3 million BTU's.
This is Pre-Piped but the Installer will need to finish connecting the piping both to the Pull Station AND inside of the exhaust plenum after the hole for the Exhaust Duct is cut.
