EXCLUSIVE FORUM FOR MACHINE DISMANTLERS AND REPAIR PEOPLE > Gary Indiana
> Sealey supermig 250 / 270 spring for shroud / nozzle
Sealey supermig 250 / 270 spring for shroud / nozzle
This spring fits onto the end of the swan neck so that the shroud / nozzle can be pushed over it. The spring holds the shroud in place. It is only suitable for shrouds with 15mm I.D. (at the insulated end) and should not be confused with a similar spring on the smaller Supermig torches. It is suitable for the torch on some of the more powerful Sealey mig welders.
Models with torches that can use this spring include:
The above welders have euro-connector torches, so if you have bought one second-hand it may not have the original torch, or it may be that the original owner chose a torch model other than the standard one. It may have a torch with a lower ampereage rating or a higher rating. It may even have been fitted with a completely different brand of torch. Please bear these factors in mind when deciding if this spring is suitable for your torch, and compare the image and description in this listing with your existing spring. It may help if you have a look at other parts in this category, particularly the Supermig 250 tip holder.
If you have a Sealey mig not listed above but you think this spring may fit your torch, please enquire and we'll find out for you.
